Throw a creamer

A little milk jug with a lip and handle. The faint guide on the wheel shows the shape; you get the right amount of clay.

Step 1 of 13: Center the clay

    Water: good

    Tap to start, then press and hold the clay to center it.

    Clay

    Clay amount (free throw)

    (settings, shelf, streak and badges, kept only in this browser)

    The guide shape, side view

    The creamer in this game

    A little milk jug with a lip and handle. A tiny pitcher: same steps, half the clay.

    Height9 cm (3.5 in)
    Widest point8 cm (3.1 in)
    Wall to aim for0.4 cm
    Clay you start with170 cm³
    Clay left in the finished form93 cm³
    Added partsa handle, a pouring lip
    Difficulty hereEasy

    Sizes are the game's guide shape, rounded; real pots in this style vary. Inches use 1 in = 2.54 cm (NIST Handbook 44, Appendix C). The clay you start with is the finished volume plus about 40% for trimming and the slurry that comes off your hands.

    Steps for this shape

    1. Center. You start with about 170 cm³ of clay. Hold it on a fast wheel until the wobble is gone.
    2. Open. Press down to a floor about 1.1 cm thick (the extra is trimmed later), then drag out to a floor about 5.2 cm across.
    3. Pull. Pull the wall up to about 9 cm. Aim for walls near 0.4 cm thick: thinner looks fine but slumps first.
    4. Shape. Grab the wall where the form is widest (about 8 cm across) and drag it out slowly.
    5. Finish. Level the rim with the needle, wire it off and trim a foot, then pull a handle down the side, pinch a pouring lip.

    Glazes to try

    Any of the 50 glazes works; these suit the creamer.

    • Rose pinkGlossy pink with a deeper rose edge.
    • Rust matteMottled iron orange with dark patches.
    • Sunset ombreGolden at the rim fading to coral at the foot.
    • Bronze metallicDark satin bronze with a soft metal sheen.