Throw a tall vase

A tall shoulder vase with a flared lip. The faint guide on the wheel shows the shape; you get the right amount of clay.

Step 1 of 13: Center the clay

    Water: good

    Tap to start, then press and hold the clay to center it.

    Clay

    Clay amount (free throw)

    (settings, shelf, streak and badges, kept only in this browser)

    The guide shape, side view

    The tall vase in this game

    A tall shoulder vase with a flared lip. Pull it tall as a cylinder first, then belly out low and collar the neck.

    Height26 cm (10.2 in)
    Widest point14.4 cm (5.7 in)
    Wall to aim for0.5 cm
    Clay you start with673 cm³
    Clay left in the finished form452 cm³
    Added partsNone
    Difficulty hereHard

    Sizes are the game's guide shape, rounded; real pots in this style vary. Inches use 1 in = 2.54 cm (NIST Handbook 44, Appendix C). The clay you start with is the finished volume plus about 40% for trimming and the slurry that comes off your hands.

    Steps for this shape

    1. Center. You start with about 673 cm³ of clay. Hold it on a fast wheel until the wobble is gone.
    2. Open. Press down to a floor about 1.2 cm thick (the extra is trimmed later), then drag out to a floor about 8 cm across.
    3. Pull. Pull the wall up to about 26 cm. Aim for walls near 0.5 cm thick: thinner looks fine but slumps first.
    4. Shape. Grab the wall where the form is widest (about 14.4 cm across) and drag it out slowly.
    5. Collar. Squeeze the top in to a neck about 6.4 cm across. Each squeeze thickens the wall, so you can pull it again.
    6. Finish. Level the rim with the needle, wire it off and trim a foot.

    Glazes to try

    Any of the 50 glazes works; these suit the tall vase.

    • Ocean dripNavy that runs in pale blue streaks down the side.
    • Berry ombrePale pink down to dark berry.
    • Soda blue flashBlue-gray orange peel with a warm flashed side.
    • Tomato redGlossy red with dark edges, like a ripe tomato skin.